Protected: Multi-VLAN and Dynamic VLAN Roaming with Grandstream GWN76XX Access Points
There is no excerpt because this is a protected post.
There is no excerpt because this is a protected post.
There is no excerpt because this is a protected post.
Description This article describes the behavior of whether the Grandstream GWN76XX meshed access points (Range Extender RE) are set in DHCP mode or Static IPs. When the REs are configured with Static IPs, they may go offline and cannot be discovered even if the LEDs are solid blue. It is recommended to configure the REs … Read more
There is no excerpt because this is a protected post.
Description VLANs require a router or Layer 3 device for inter-VLAN communication, while a Layer 3 switch can perform routing between VLANs internally, eliminating the need for an external router. This guide describes the steps on how to create static routes in Grandstream Wi-Fi router GWN7062 and Layer 3 managed network switch GWN781x series. In … Read more
Description This article describes the steps to configure ACL to block access from IP Phones to PCs in the Grandstream GWN78XX switch. SW1 (config) # deny ip icmp 192.168.20.1 host 192.168.10.1 SW1 (config) # permit ip any any Network Diagram VLAN 20 for IP Phones: 192.168.20.xVLAN 10 for PCs: 192.168.2.x How-to 3. Configure another rule … Read more
Description Destination NAT or DNAT, changes the destination address in the IP header of a packet and the destination port in the TCP/UDP headers. It is used to redirect incoming packets with a public address/port to a private IP address/port in your network. Configuration steps: Note Port forwarding rules must be removed (not disabled) in the router. Otherwise, it … Read more
Description This article describes the site-to-site IPSec configurations in Grandstream router GWN700x series when it is behind NAT (SonicWall). How It Works IPSec needs to check the Peer’s ID during authentication. The Grandstream router GWN700x uses the IP address of the WAN port as the IKE ID (Local ID/Remote ID) by default. If the router … Read more
Description This article describes the behavior of Grandstream GWN700x series routers always showing zero Upload or Download Speed for the Client devices. When the Hardware Acceleration is enabled under Network Settings > Network Acceleration, the offload packets from the CPU are not counted The packet will be offloaded only if: a. It is the first … Read more
Description This article describes the steps on how to configure the Grandstream GWN7052/7062 router for Maxis Home Fibre Internet. Maxis Home Fibre delivers its fibre connections with PPPoE with a VLAN tag. Steps 2. Navigate to the Network Settings > WAN on the home screen, and select Connection Type: Internet Access with PPPoE account. Enter the required … Read more